"This part is held in place by four plastic clips that are attached to the tail light lens. The detents on plastic circuit board housing did not line up with the clips. They were off by more than .125 inch. Tried filing the plastic to get it to fit but was unsuccessful."posted by: Jim on August 22, 2012
$259.25List Price $357.73Save $98.48Availability: In Stock
Free Ground Shipping
Low Price Guarantee
AIR LIFT LOAD CONTROLLER SINGLE ON BOARD AIR COMPRESSOR SYSTEM -- Consists of heavy duty compressor, analog single gauge, low pressure sensor, wiring harness, air lines, air fittings, and other mounting hardware; Able to rapidly inflate and deflate two air springs at the same time while on the go; Features low air pressure sensor that automatically activates to maintain minimum required pressure levels; Ideal for light to medium duty applications.
"The Installation took about 4.5 hours. The instructions tell you not to put the compressor under the hood or were it can get wet but shows it mounting on the frame. So where do you put it? The wiring harness section closest to the guage is too short to connect to the power(under the hood). Had to slice in longer wires. However once it was all complete I am very happy with it."posted by: TAS on October 4, 2013