How to Fix a Broken Honda Grille Assembly
Being in the forefront of your vehicle-literally-the grille assembly is prone to getting scratched and damaged. Although these protectors are made from high-quality materials that are built to last, it is inevitable that, at one point or another, they will succumb to wear and tear. It is important that you know when to take action before it gets you in an accident. Why? A broken grille can fall off the road and cause various accidents. Before this happens, you need to replace your Honda grille assembly with a new one, or you can just fix it. Here's an easy step-by-step guide that you can follow.
Difficulty level: Moderate
What you'll need:
Step 1:Park your vehicle in a shady area before you start with the repair. This is to ensure that you will not rush the repair just because the weather condition or the temperature is not right.
Step 2:Remove the screws from the grille using a screwdriver. Examine the mount area from under the car if it is in good condition. Check if they are easily accessible.
Step 3:Prepare a ¼ black thick Plexiglas and cut a strip about an inch wide once you've confirmed that the mounting holes are accessible. Next, clean the bottom of the grille where the tabs used to be using a mild soap and clean cloth.
Step 4:Mount the grille in place on your vehicle. Make sure that it is at the center and aligned in all sides. You can mark the area using a non-permanent marker to ensure that it will be at the correct position.
Step 5:Cut two tabs from the Plexiglas strip, and then divide it into two tabs. You should come up with two tabs that are about an inch long. Using sandpaper, scratch one of the edges clean and coat it with an adhesive. You can use superglue for plastic.
Step 6:Go beneath your vehicle and stick the tab through the slot and onto the grille. Keep it on for at least 15 seconds. Do the same with the other tab.
Step 7:For the center part, glue two pieces of the tab material to make it thicker. Glue it onto the grille as well. Leave them on for at least five minutes.
Step 8:After the tabs have dried, remove the grille from your vehicle. Use a plastic epoxy that is specifically made from plastic repairs, and then form a fillet-shape around the base of each of the three tabs where they coincide with the grille. This is to reinforce the grille and keep it from falling.
Step 9:Once the tabs are hard enough, you may file, sand, and drill the pieces back on the Honda grille assembly. It would take you at least 15 minutes to put this together and ensure that they will remain intact. Take your vehicle for a short ride to ensure that it will not fall off.
And just like that, you just saved your money from buying a new replacement Honda grille assembly. This repair can only do so much; you always have the choice whether you will invest on a new one or keep repairing it by yourself.